How To Make A Good Graphite Fishing Rod

By Linda Wilson

Did you know that the blanks used in fishing rods are made of composite or impregnated carbon fibers?

It is after going through a lengthy process and a high cost that they are eventually produced at a chemical factory and not by the hands of a rod builder. It has been seen that these blanks rather than making fishing rods actually end up predominantly being used in automobile and aerospace industries.

Can Be Both
The blanks are commonly known as carbon composites or graphite. If you were to view one of these blanks at the atomic level each individual particle would be identified as carbon. The composite is formed when two or more materials are blended together to give the blank certain desired characteristics which in our case was to make it tough. The molecular pattern shows graphite. So it can be named composite as well as graphite.

Composite For Fishing Blanks
Companies use the composites to make fishing blanks. There are many kinds available and each company will decide depending upon the blank’s composition, requirement, and weight per square meter, orientation and content of resin their final destination. The important thing to remember is that the carbon in these composites is actually in the graphite form making it right for a raw material for the fishing blanks which need to be strong and resistant to force.

Composite of Composites
Fishing blanks are made using carbon composites and other materials which are added like ceramic, glass fibers, or boron to make separate coatings. More than one or two such preparations are used to make different parts of the rod.

High Modulus and Force
Among the many carbon fibers chosen to make fishing rods the ones with higher modulus and strength are the best as they are able to pile more energy and discharge it. Modulus can be calculated with the stiffness and the weight of the graphite blank.

What is Modulus?
Modulus is the energy measured with the speed and the power of the rod. It is similar in nature to jumping off a diving board. The force makes it move up and down according to the jump. Also, a fishing blank which has a “modulus” is highly priced and is flimsy to use.

Remember This
If you intend to make custom rods, be warned that your rods will need high tech machines which will make the designing, heating, pressurizing and cooling easy while combining the use of an economical modulus. So this is not going to get done by anybody else than professionals.

Buying good quality blanks from the producers could help you out. If you are interested in bamboo rods, then Tonkin cane is what you need. Take care to maintain control over processing to get the desired taper and action.

Finding The Blank’s Spine

Find More Related Fishing Tips At Fishing Tips